
Thursday I went to Ignacio, Colorado to do a job for a client of mine that was in a bind. I left from Montezuma Creek and began the trek to the job site near the La Plata County Airport. When I arrived I noticed it was exceptionally muddy and that this job was going to be a blast. I proceeded to the pipeline and as you can see from the picture I got stuck. And not only did I get stuck to the point that I had to have heavy equipment remove me from my situation, I needed him to pull my truck for an additional quarter mile until I could drive again. Actually is was more like gravity pull my truck down hill while all the wheels were locked. Once I finished with my "downhill skiing" I needed to cross a small stream, by small I mean it looked to be were somebody had dumped out a water jug and had a really slow trickle. As soon as my truck got into the mess it sunk up to the decal on the side of the door (about at the top of the front tire). The bad part about this is the spotter for the equipment was in la la land and didn't notice I needed to be re-attached. So out of the truck I go and as soon as I step out of the truck I sunk to over the top of my knees. After attaching the truck and getting moving again, which wasn't an easy thing to do (there was an old grave in the right-of-way that had to be avoided in 3 foot deep mud) I was able to finish the last five welds and process all of the film. I then looked at my watch and noticed my helper and myself were able to have done 25 welds in one hour and fifty minutes, which is quite an accomplishment on a dry day.